If you do not find the answer to your question here, please ask your question using the message box on the support page
|
| Q. | What is the FLEA3? |
| A. | The FLEA3 is a low profile DCC Accessory Decoder and motor used to control the position of a turnout.
It eliminates “under the table” mounting. |
| | |
| Q. | Can the FLEA3 be purchased separately? |
| A. | No, because of tight tolerances required for satisfactory operation, factory installation
is required. |
| | |
| Q. | Do you install the Flea on customer provided switches? |
| A. | No. |
| | |
| Q. | Does the FLEA3 have the ability to power, or control power to the frog? |
| A. | Yes. It powers the frog automatically. |
| | |
| Q. | Is there any provision for control by a push button? |
| A. | Yes, the FLEA 3 may be operated by either a DCC controller or a push button. |
| | |
| Q. | What products is the FLEA 3 available on? |
| A. | The Flea is available on all Walthers HO, Code 83 switches except the 3 way switch. |
| | |
| Q. | When will you have a FLEA for N gauge? |
| A. | Currently we have no plans for an N gauge FLEA. |
| | |
| Q. | Can the FLEA3 operate on Loco Net? |
| A. | No, in order to keep the size and price low the FLEA3 is strictly DCC only. |
| | |
| Q. | Can the FLEA3 operate with any brand of command station? |
| A. | The FLEA3 should operate with any brand of command station but only the following have been
tested: Digitrax, MRC, NCE. |
| | |
| Q. | What is power routing? |
| A. | The inner rails of the outgoing “clear” or “throw” legs are automatically powered
by the corresponding switch position. |
| | |
| Q. | Will the FLEA 3 operate on DC layouts? |
| A. | No. It is designed for DCC powered layouts only. |
| | |
| Q. | What is your return policy? |
| A. | You can read about our return policy here |
| | |